ALTUA undertakes defined plasterboard installation, internal plastering repairs and make-good work for Melbourne building projects. We consider the existing substrate, required finish and adjoining surfaces before setting the scope.
A successful lining repair depends on more than the visible patch. Support behind the board, correct joint treatment and the finish expected under site lighting all influence the result.
New or replacement plasterboard lining requires suitable framing, board selection, fixing patterns and joint treatment. Wet-area, fire-rated and acoustic assemblies must follow their specified system rather than a generic lining detail.
Local repairs after services work, impact damage or alterations involve assessing the surrounding board, providing backing where required, then setting and sanding joints before the agreed finish.
Joint compounds, corner beads and finishing coats help create a consistent surface for decoration. The required finish level depends on the intended lighting, paint sheen and project specification.
Before replacing damaged lining, check whether the problem is local impact damage, an unresolved leak or movement in the supporting structure. Water-affected material should not simply be covered before the moisture source has been addressed.
Where a wall or ceiling forms part of a fire-rated, acoustic or wet-area assembly, the repair needs to maintain the specified system. The correct board type and detailing should be established before installation.
Natural light across a long wall, recessed lighting and higher-sheen paints can highlight small surface variations. The specified finish level, joint layout, surface preparation and decoration need to be coordinated rather than assessed only after painting.
Position sheets and joints with the substrate and specified system in mind, particularly around openings and transitions.
Allow appropriate compound application and drying between stages; avoid damaging the board facing during finishing.
Confirm whether priming and painting are included, and review the intended finish under representative lighting.
Alterations to partitions, ceilings, doors and building services often leave local areas requiring reinstatement. A clear scope identifies the extent of lining replacement, joint finishing, corner protection and any painting needed to return the affected area to use.
Work in occupied premises also requires coordination of dust control, access and drying time. Structural modifications, fire-rated systems and specialist compliance works must be separately specified where relevant.
Commercial Property MaintenanceExterior render repairs involve different substrates, weather exposure and coating systems from interior plasterboard work. Cracked or detached façade render should be assessed as an external building repair, rather than treated as a standard plasterboard patch.
Building Repairs & RectificationPlasterboard installation involves fixing lining sheets to an appropriate support system. Plastering may describe setting joints, applying finishing compounds or working with other plaster-based finishes. The quotation should identify which activities are included.
It depends on the source and extent of moisture exposure. Wet or deteriorated boards may need replacement, and the cause of water ingress must be addressed first. Concealed mould or affected insulation can require additional assessment and remediation.
Australian plasterboard finishing specifications commonly distinguish finish levels according to the intended decoration and lighting. Strong glancing light and glossy finishes can make joints more visible, so the required finish should be agreed before work starts.
Not automatically. Wet areas require suitable lining materials and a wall assembly consistent with the applicable design and waterproofing requirements. Moisture-resistant board alone does not replace a required waterproofing system.
No. Fire-rated wall systems depend on the complete tested or approved assembly, including board layers, fixings, joints and penetrations. Any repair must preserve the specified system and may require specialist documentation or assessment.
The repair method depends on whether the crack results from local joint failure, movement, impact or a wider building issue. Simply covering an active movement crack with compound may lead to recurrence.
A well-prepared patch can blend closely, but existing texture, paint ageing, lighting and sheen affect the final appearance. Painting a larger continuous area may be needed for a consistent visual finish.
Send photographs, approximate dimensions, ceiling height, the location and type of damage, access information, and whether painting is required. For new linings, provide drawings and any acoustic, fire or moisture-performance requirements.
